Another potential orientation would reduce the assist materials used. This orientation will decrease the amount of cleanup and print time, if high precision machining the software is required as quickly as potential, nevertheless it is not going to be quite as robust in the desired direction. This orientation could give the strongest part for a wing utility. However, gently sloped surfaces like that on the top of our airfoil can typically seem tough when created with FDM 3D printing. This is brought on by breaking down a precise clean floor into a “stepped surface”, the place the layers are stacked one on prime of another.
Another potential orientation would reduce the assist materials used. This orientation will decrease the amount of cleanup and print time, if high precision machining the software is required as quickly as potential, nevertheless it is not going to be quite as robust in the desired direction. This orientation could give the strongest part for a wing utility. However, gently sloped surfaces like that on the top of our airfoil can typically seem tough when created with FDM 3D printing. This is brought on by breaking down a precise clean floor into a “stepped surface”, the place the layers are stacked one on prime of another.
ОтветитьУдалить